This is not needed anymore. The infomation below is Copyed from Axminter.The tool is clamped into a holder mounted on the end of a pivot leg; the end of the leg rotates in a conical housing in the horizontal support bar. Grinding of gouges is carried out by rotating the tool from side to side whilst parting tools, skew chisels and the like are laid flat on the wheel at the correct angle. For that classic fingernail profile with swept back wings on your bowl gouges, this is the jig that will produce it with one perfect single facet bevel. This also comes with Woodcut Tru-Grind Sturdy Rest The sturdy rest from Woodcut meets these requirements and is a very useful addition to the Tru-Grind system. It conveniently pivots down out of the way when not required, allowing you to use the jig for your gouges and other turning tools. A link on how to use.
The item "Sharpening System for woodturning tools" is in sale since Tuesday, June 2, 2020. This item is in the category "Home, Furniture & DIY\DIY Tools & Workshop Equipment\Power Tools\Lathes". The seller is "greenwoodcrafts2010" and is located in York. This item can be shipped to United Kingdom, Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Australia, United States, Bahrain, Canada, Japan, New Zealand, China, Israel, Hong Kong, Norway, Indonesia, Malaysia, Mexico, Singapore, South Korea, Switzerland, Taiwan, Thailand, Bangladesh, Belize, Bolivia, Brunei darussalam, Dominica, Egypt, Guernsey, Gibraltar, Guadeloupe, Grenada, French guiana, Iceland, Jersey, Cambodia, Saint kitts and nevis, Liechtenstein, Macao, Monaco, Martinique, Nicaragua, Pakistan, Paraguay, Turks and caicos islands, Aruba, Saudi arabia, United arab emirates, Chile, Bahamas, Costa rica, Dominican republic, Guatemala, Honduras, Jamaica, Kuwait, Panama, Qatar, El salvador, Trinidad and tobago, Uruguay.